1911 Grips – Red Laminated Wood Grip Panels, Double Diamond Checkered, Full Size

These 1911 grips in red laminated wood give your pistol a classic look and a firmer hold. Each panel carries traditional double-diamond checkering, and the layered red and black laminate shows through the cuts for a rich, two-tone finish. The set comes as a pair, left and right, and installs with your existing grip screws. If you also want to add a red dot, see our pistol red dot mount plate with a 1911 option, or browse more 拳銃用アクセサリー.

Why Choose These 1911 Grips in Red Laminated Wood?

Worn or plain grips can make a well-kept 1911 look tired. By contrast, a fresh set of laminated wood grips restores the classic look while the checkering improves your hold, especially with sweaty or cold hands.

In addition, laminated wood is built from thin bonded layers. As a result, it shows a distinctive striped edge and resists splitting better than a single solid block.

Key Features of the Laminated Wood 1911 Grips

• Double-diamond checkering: a traditional pattern with smooth diamonds around each screw hole.
• Red and black laminate: layered wood gives a two-tone finish that shows in the checkering and along the edges.
• Improved hold: the checkered surface adds texture compared with smooth grips.
• Thumb relief cut: the left panel is relieved for the magazine release.
• Complete pair: left and right panels included.

1911 Grip Panel Compatibility

These grip panels are designed for full-size, single-stack 1911 frames. Compact, Officer-size and double-stack frames use different grip shapes, so check your frame before ordering. Because 1911 frames from different makers vary slightly, some light fitting may be needed.

仕様

Key details for these red 1911 grips are listed below.

What’s in the Box

• 1 × left grip panel
• 1 × right grip panel

Grip screws are not included. Reuse the screws from your current grips.

How to Install 1911 Grip Panels

1. First, unload the pistol, remove the magazine and confirm the chamber is empty.
2. Remove the grip screws and lift off the old panels.
3. Fit the new panels over the grip screw bushings, with the thumb relief cut on the left side.
4. Then refit the screws and tighten them snugly, without over-tightening, to avoid cracking the panels.

1911 Grips FAQ

Are grip screws included?
No. The panels are made to use the standard screws already on your 1911.

Will they fit my compact 1911?
No. They are sized for full-size single-stack frames only.

Is the color the same on every set?
Because laminated wood is a natural material, the grain and shade can vary slightly from the photos.